New Page 1

Finishing Kit

	< Rear compartment - Altrak programmer and wires,, Servo and Strobe power. >
	< Circuit Breakers and wiring, under the arm rest. Just working out where to put the data plate >
	< (Pitch) trim wheel and the edge of the rear throttle. Electric aileron trim (wires hanging). Double friction lock, throttle quadrant ( lower tab locks prop and mixture, and black tab locks throttle), Throttle was also modified for a PTT switch. The switch just below the mixture is for flaps (rocker switch) >
	< In preparation of mounting the engine, started to reorganize... Outside with engine mounted ! >
	< Hopefully this will give me a little bit of room around the front, to work,,, (still have some junk to put back into the shop). I clamped the front screen to the roll bar, then projected where the top skin would go (red arrow & line) >
	< After trimming towards the line, I installed the top skin and started making cuts toward the line. After each cut I'd fit the windscreen with the roll-bar and top skin, then "adjust" the line I need to cut to. >

[ Page 1] [ Page 2 ] [ Page 3 ] [ Page 4 ] [ Page 5 ] [ Page 6 ] [ Page 7 ]