|
Fuselage |
 |
<< Green arrows - rudder cables holes; Blue-
holes for running various wires; Red - error, kinda, drawing 11 shows the
nutplates, but the gear weldments cover the two inboard nutplates ... if
you're building an -8a at least fit the weldments FIRST.
Just checking the floor structure out >>
|
 |
 |
<< fitting the gear weldments to the center section
... slight radius trim on the bottom,, the weldments "relief" hole and the
bottom rivet didn't line up (Red arrow),, I ended up replacing the AN470
rivet with a 426.
Longerons cut for F811 bars>
|
 |
 |
< Starting with the skin panels > |  |
 |
<Brackets attached to the floor structure; electric aileron
trim and Digitrak autopilot.
Checking the alignment of the mid-cabin skin> |
 |
 |
<Gusset for the F804 and longeron Mid-Cabin skins: Edges rolled for F807 > |
 |
 |
<Rear side skins going on
I'm out of Clecos.... and I still have the bottom and floor skins to go >> |
 |
[ Fuselage - Page 1 ] [ Fuselage - Page 2 ] Fuselage - Page 3 [ Fuselage - Page 4 ] [ Fuselage - Page 5 ] [ Fuselage - Page 6 ]
[ Fuselage - Page 7 ] [ Fuselage - Page 8 ] [Fuselage - Page 9][Fuselage - Page 10 ] [ Fuselage - Page 11]
[ Home Page ] [ Empennage ] [ Wing Kit ] [ FWF ] [ Panel/Interior ] [ Finishing Kit ] [ Misc ]