I'll wait for the engine install, before riveting the front to the firewall >
Gap at the bottom of the step >
( I ended up, putting custom made taper shims in )
Step,, gap tapers between the arrows >
|
Fuselage |
|
<Work on cooling ramp begins > | |
|
< Cooling Ramp in place
I'll wait for the engine install, before riveting the front to the firewall > |
|
|
<Template for the boarding step
Gap at the bottom of the step > ( I ended up, putting custom made taper shims in ) |
|
|
< Dowel representing the rudder cable
Step,, gap tapers between the arrows > |
|
| If you get the step to set flat on the skin,, the inside part of the step interferes with the rudder cable.. so you can 1. cut a hole in the step (see Bill Von Dane's website),, 2. heat the tube and bend it.. (I already chromed the step .. (so I wasn't gong to chance coloring the chrome),, or 3. shim the gap. | Skins deburred, dimpled,,, ready for assembly > | |
[ Fuselage - Page 1 ] [ Fuselage - Page 2 ] [ Fuselage - Page 3] [ Fuselage - Page 4 ] Fuselage - Page 5 [ Fuselage - Page 6 ]
[ Fuselage - Page 7 ] [ Fuselage - Page 8 ] [Fuselage - Page 9][Fuselage - Page 10 ] [ Fuselage - Page 11]
[ Home Page ] [ Empennage ] [ Wing Kit ] [ FWF ] [ Panel/Interior ] [ Finishing Kit ] [ Misc ]